Ultra-Fast Automated Ultrasonic Testing (UAUT)

Guided Wave Ultrasonic Testing (LRUT)

LRUT is primarily a screening tool. The aim of the inspection is to test long lengths of pipe rapidly from a single test point with 100% coverage of the pipe wall and to identify areas of corrosion.

Acoustic Emission

Acoustic Emission technology has for a number of years been used to monitor the active corrosion condition of Above Ground Storage Tanks floors. This technique provides a non-intrusive method of determining the active corrosion condition of tank floors without the need to open, clean and inspect. Costs involved in cleaning and inspecting a tank floor can be very high, and if the floor after inspection proves to be in a good condition, then the time and cost could have been better used elsewhere.

Magnetic Flux Leakage

In MFL technology, the component required to be tested is magnetized to a saturation level at which the presence of a significant local reduction in material thickness causes distortion of the internal magnetic field, allowing flux lines to break at the area of the discontinuity. With MFL, sensors are used to give an electrical signal at the leakage site. This signal operates an audible or visual alarm to alert the inspector or stores the event for computer mapping of the area.

Pulsed Eddy Current

We also offer Pulsed Eddy Current (PEC) inspection technology for the detection of corrosion areas in carbon and low alloy steels. Measurements are taken through any non-conductive material e.g. insulation, protective coatings, concrete and marine growth.

Cathodic Protection (CP) Systems And Other Niche Protection Systems

System design and installation supervision for CP systems Audit and troubleshooting & modifications or upgrading in existing systems by capacity enhancement CIPS and DCVG survey Remote Pipe-to-Soil Measurement Monitoring Unit.

Specialised Inspection And Modified Surveys Methodogies

We utilize innovative methods and technologies, apart from the conventional methodologies used in the industry. We do not reinvent the wheel but take a “common sense” approach to your problem and coming out with a relevant solution.